ConnectWare2 Regulatory Compliance

Owned by Ricky Goldfarb
Last updated: Dec 24, 2024
2 min read

  • FCC Part 15, Subpart B, Class B

  • CE, RoHS, ISED ICES-003

  • Contains FCC ID: 2ADHK-WFI32E01

  • Contains IC: 20266-WFI32E01

Certifications

EC Declaration of Conformity

FCC Compliance Report Cover

CE RoHS & REACH Statement

Pre-Certified Radio Declarations

Product Label

image-20241224-160931.png

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The antenna used for this transmitter must be installed to provide a separation distance of at least 8cm from all persons.

Canadian Compliance Statement

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference;

  2. This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

  1. L’appareil ne doit pas produire de brouillage;

  2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Modification statement

Powerhouse Dynamics has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user's authority to operate the equipment!

OEM Instructions


The ConnectWare module contains a Pre-Certified Radio in compliance with FCC and RED directives. Providing your testing laboratory copies of the attached declarations along with other critical component documentation should allow the testing laboratory the necessary to avoid repeating ETSI EN 301 489 radio testing as long as all other conditions of use are met.

This module is certified for installation into OEM end-products under the following conditions:

The intended use of this product is for dry indoor locations.   This product is not IP (Ingress Protection) tested, but it is designed to meet IP50 (Dust resistance 2-8 hours) and no liquids protection.