When setting up a ConnectWare® Module without a Secure Access Point (SAP), you will need to reference the serial number of the module. The images below highlight where to find the serial number.
ConnectWare Module Version 1
ConnectWare Module Version 2
Installation Steps:
Align the connector between the module and the ConnectWare® Dock or ConnectWare® Cable Adapter.
Secure with two screws.
If the module will be connecting through Wi-Fi (CWM version 1 or 2):
Enter the network credentials into the touchscreen of the connected device. Instructions for navigating through the equipment’s user interface should be provided by the original equipment manufacturer. At present, this functionality is only available to some models of equipment that have an HLUI.
If the module will be connecting using Ethernet (CWM version 2 Only):
Remove the cap to open up the Ethernet port.
Attach the rubber O-ring over the threads at the base of the module. (first image below)
Assemble the cable clamps onto the Ethernet cable. (second image below)
Plug in the Ethernet cord.
Thread the clamp body, gasket, and nut over the connector. (third image below)
