...
The first production run of direct docks had an assembly stack up which may cause the connectors not to mate properly in rare cases.
SOLUTION:
Remove the wireless module from its dock by unscrewing two #10 screws. |  |
Identify the dock version.
Version A: Continue to the next step of this procedure
Version B: STOP. This procedure does not apply. |
|
Using a small screwdriver, peel off the gasket from the dock and discard. |
|
Replace the wireless module. Secure with two #10 screws. |
|
Reboot equipment
Inspect the PCB on the back of the dock. If a jumper is installed, remove and discard it. |
 |
Reboot Equipment |