Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 6 Next »

ConnectWare2 has been tested by a third party NRTL and meets the following regulatory requirements.

  • FCC Part 15, Subpart B, Class B

  • CE, RoHS, ISED ICES-003

  • Contains FCC ID: 2ADHK-WFI32E01

  • Contains IC: 20266-WFI32E01

Product Nameplate

The supplied label must be attached to an exterior surface of the OEM equipment.

image-20240628-195522.png

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Canadian Compliance Statement

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference;

  2. This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

  1. L’appareil ne doit pas produire de brouillage;

  2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Modification statement

Powerhouse Dynamics has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user's authority to operate the equipment!

Only the antenna supplied by Powerhouse Dynamics may be used to maintain compliance with the pre-certified radio. Use of an unapproved antenna that does not meet the same specifications will nullify the certification of the radio.

OEM Instructions


This module is certified for installation into OEM end-products under the following conditions:

The intended use of this product is for dry indoor locations.

  • No labels