...
Open a browser, and navigate to http://172.16.99.1:8080/
You can now change from DHCP to Static configuration and enter your preferred settings.
Press the Update button and the prompt to restart to apply the changes to save the configuration.
...
Go into your phone or laptop’s network settings. Disconnect and forget the ConfigSiteSageSAP network.
Wait roughly 60 seconds for the 2G or 5G LED to become active again.
Then, change the toggle switch to its original position.
Wait 30-45 seconds. If the ConfigSiteSageSAP network is broadcasting after reset, change the state of the toggle switch again. The network should disappear after 15 seconds.
If you make a mistake or need to reconfigure the SAP for any reason, you can repeat the above steps.Should you get stuck and need to
...
Factory Reset
...
If the device appears to freeze during the configuration process, you can attempt a factory reset to resolve the issue.
Before attempting a factory reset, the SAP must be powered on and have an active 2G or 5G LED.
You can initiate a factory reset by pressing and holding the reset button for 10-20s. at least 10s.
Wait 3 minutes before interacting with the SAP again.
After a factory reset, the SAP will be back in DHCP mode.
...