...

View file
name DOC-000052-03.pdf

Primary dimensions are in millimeters.

Overall Dimensions

...

Enclosure Preparation for Window Option

The dimensions below identify the opening in the exterior surface of the OEM equipment. If a location has not yet been selected, see the section on window placement. The cutout dimensions are the minimum dimensions for access of the internal Wi-Fi antenna signal as well as visibility of the LEDs. All hardware is supplied by the OEM integrator. M3 hardware is depicted below, however 4-40 can also be used if desired.

...

Solidworks model for example cabinet wall.

View file
name cabinet_wall.zip

...

Window Assembly

The window is clear, hard coated polycarbonate with scratch resistant coating. There is a decal on the inside surface. The external surface is washable. The 3D model and spare part number is

View file
name 330-000014.STEP

Attach window to cabinet wall using two M3 hex nuts. Orient the window with the graphics facing out. Add a thin bead of silicone to the front side of the window for added water ingress protection if desired.

...

PCB Assembly with Window Option

The PCB

View file
name 250-000052-01.step

is assembled on top of the window using four M3x6mm button head cap screws. Orient the PCB with connectors side out. Allow for 3.0” space under the connectors to allow for cable bend radius and disconnection. Secure cables to chassis to prevent strain on connectors.

Product Nameplate Label

The label supplied with the ConnectWare2 Slim kit contains necessary serial number, network address, and regulatory compliance information. The label dimensions are 63mm x 38mm

...

Note
If the PCB is replaced for any reason, the label must be replaced as well.

...

Optional External Antenna Mounting

The antenna cable connects to the PCB where shown. It is important to add strain relief to this cable nearby to the PCB to avoid damage. The cable diameter is 1.3mm. Locate the antenna within reach of the 1 meter cable. Loop excess cable with minimum 3” bend radius. Do not fold or bend the coaxial cable.

...

The antenna end of the cable is a rear mount, front nut bulkhead type. A 0.25” or D style hole is required to mount the cable to the cabinet. The antenna is a screw on swivel style connection. Recommend shipping the antenna removed from the enclosure if it will be susceptible to damage during shipping and installation.

...

Thermal Consideration

The standard configurations without battery backup have a maximum operating temperature of 85°C.

...