...
Take photos of each thermostat with current set-points, mechanical settings, wiring at backplate
Verify pre-requisites including common wire, compatibility, etc.
Verify if remote sensors are in use
If so, validate that they are wired, and wiring is compatible (see remote sensor compatibility doc).
Validate remote sensor location and ensure no interference / blowers / exterior non-insulated walls, direct sunlight, etc.
🚨 If remote sensors are incompatible or must be relocated:
Verify permission for additional scope
Verify is if running new remote sensor wire is possible
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
Drop ceilings or surface mount preferred. |
3. Run new 18/2 shielded, making sure remote sensor wire is run separately from the bundle.
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
If any issues or non-compatibility are found during pre-install testing, contact our Technician Support team right away. |
...
Take photos of the electrical panels and panel schedules with the mobile app.
Locate circuits to be monitored per SOW and ensure panel schedules clearly identify desired circuits.
If circuits are not labeled, determine if circuit tracing can be completed
Added scope will. 🚨 Added Scope would need to be approved.
Determine if there is sufficient space in panel to capture main feeds.
...