Before you begin installing any Powerhouse Dynamics hardware, please completed the following testing and take photographs of the existing set up.
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
If any issues or non-compatibility is found during pre-install testing, contact our Technician Support team right away. |
| Table of Contents | ||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
📝 Roof Top Units
Test rooftop units by engaging heating and cooling at each unit from existing thermostats.
...
Verify permission for additional scope
Verify is running new remote sensor wire is possible
Drop ceilings or surface mount preferred.
Run new 18/2 shielded, making sure remote sensor wire is run separately from the bundle.
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
If any issues or non-compatibility is found during pre-install testing, contact our Technician Support team right away. |
...
Take photos of the electrical panels and panel schedules with the mobile app.
Locate circuits to be monitored per SOW and ensure panel schedules clearly identify desired circuits.
If circuits are not labeled, determine if circuit tracing can be completed
Added scope will need to be approved.
Determine if there is sufficient space in panel to capture main feeds.
| Panel | ||||||
|---|---|---|---|---|---|---|
| ||||||
If any issues or non-compatibility is found during pre-install testing, contact our Technician Support team right away. |
...